Driveways, patios, walkways, stucco and siding cleaned at the right pressure for the surface.
Most pressure washing horror stories come from one mistake: too much PSI on the wrong surface. Stripped paint, gouged wood, etched concrete, blown-out grout. Pressure washing is as much about restraint as it is about power.
No, and that is the whole job. Concrete tolerates high pressure. Stucco, painted siding, wood and mortar do not. The right approach matches pressure, water temperature and cleaning solution to the material, which is why one machine setting cannot clean an entire property.
Pressure washing uses force to blast contamination off hard surfaces. Soft washing uses cleaning solution to break down algae, mildew and grime, then rinses at a pressure closer to a garden hose. Choosing wrong is how siding ends up stripped and mortar ends up on the ground.
Our crews carry commercial hot-water units, dedicated surface cleaners for flatwork, soft-wash chemistry for delicate materials, and a range of tips. Picking the right combination for each surface on a property takes judgment that comes from decades of doing it, not from a setting on a machine.
Red dirt works its way into concrete pores and stains them a dull orange. North-facing walls and shaded patios grow algae and mildew where moisture lingers. Driveways collect oil drips, tire marks and rust rings from irrigation. Monsoon splash-back throws a band of grime up the bottom two feet of every wall.
Cleared off, a property tends to look years younger, because most of what reads as age is simply buildup. The surfaces underneath are usually in better shape than anyone expected.
We handle residential driveways, patios, walkways, decks, fencing and full house washes across Prescott Valley and Prescott. On the commercial side we clean storefront entries, sidewalks, dumpster pads and parking areas, often on a recurring schedule so the property never drifts far from presentable.
We look at the property, count the panes, note the hard-water damage and give you a firm price before anything starts.
Drop cloths go down and screens come out labeled. Then every pane gets hand-detailed inside and out.
We check the glass in raking light together. Anything you are not happy with gets redone on the spot.
Not when the pressure matches the surface. Stucco and painted siding get a soft wash, which relies on cleaning solution and a low-pressure rinse rather than force. The high-pressure equipment stays on concrete, where it belongs.
Usually, yes. Fresh oil lifts readily with a degreaser and hot water. Older stains that have soaked deep into the concrete often fade substantially rather than vanish, and we will set that expectation before we start rather than after.
An average home takes two to four hours depending on pane count and how much restoration work the glass needs. We will give you a time estimate with your quote.
Only if we need interior access. Exterior-only work can happen while you are out, and we will text you when the crew arrives and when we finish.
Clean glass sheds rain without spotting, so a shower will not undo the work. Dirty glass is what turns rain into streaks.
Serving Prescott Valley and the surrounding area. Use the form below to request an estimate.
Get a Free QuoteLeave your contact details and Alexander’s Window Cleaning will follow up about your project.
Window cleaning, pressure washing, window restoration, and windshield restoration in Prescott Valley and Prescott.
If the form does not load, open the contact form.